Page 1 of 1
Can´t test maps
Posted: Thu Aug 13, 2015 5:01 pm
by OP Archer
I out this here because the maps are only testable with the rpg. I have the rpg but when I click on Start on the editor it exits and says a problem with blah blah blah blah I don´t even bother reading. Why does it exit? I mean I could test my first 2 maps so it´s a editor problem... HELPY REQUIRED
Re: Can´t test maps
Posted: Thu Aug 13, 2015 5:56 pm
by Asmodeous
A good start would be posting what its saying the problem is.
Re: Can´t test maps
Posted: Fri Aug 14, 2015 12:12 am
by Insider
You should have read this part of map editor instructions:
Instruction wrote: Simulation
To start simulation click Scenario button then click Start.
Simulation parameters are loaded from file test_run_file.
This file shoud be self explanatory. Avialable FIGHT_WEAPONs are: SWORD=0, BOW=1, AXE=2, CLUB=3, WAND=4
To add new enemy, npc, chest or bulding click on chosen unit. To remove building or chest click with pressed shift.
To remove enemy click Clear NPC.
Re: Can´t test maps
Posted: Fri Aug 14, 2015 1:21 pm
by OP Archer
i readed everything, I developed in total 3 maps...
Re: Can´t test maps
Posted: Fri Aug 14, 2015 3:57 pm
by Insider
OP Archer wrote:i readed everything, I developed in total 3 maps...
You can test it with simulation feature
